OBH Nordica sharpX-treme 9967 Instructions Of Use page 17

Replacing the diamond wheel
After approximately 2 000 repetitions you might have to replace the diamond wheel with
a new one (can be ordered from OBH Nordica phone 08-445 79 00). Make sure that the
appliance is unplugged before you open the appliance. Open the lid underneath the appliance
by unscrewing the two screws. Remove the diamond wheel by pulling it out of the notch and
lift it upwards. Place the new wheel into the wheel compartment by pushing the peg into the
notch. Put the lid back and tighten the screws. Note that the ceramic wheel do not need to be
replaced since it is not exposed to the same kind of strain.
Cleaning
Wipe off the outer housing with a damp cloth and dry.
The sharpening-wheels can be cleaned with a small brush (for ex. a toothbrush) that is held
towards the wheel while rotating.
If you wish to remove eventual grinding dust that is collected inside the appliance, unscrew
the lids positioned underneath the appliance and shake out and/or use a vacuum cleaner to
suck out eventual dust from the opening. Always unplug from the mains supply before the
lids are removed!
Put back the lids and tighten the screws.
Safety instructions
1. Read the instruction manual carefully before use, and save it for future use.
2. Plug the appliance to a household outlet of 230V only, and use the appliance only for the
intended use.
3. Always unplug the appliance from the mains supply when disorder is experienced, when
not in use, when parts are applied or removed from the appliance and before cleaning
and maintenance.
4. The appliance must not be immersed into water or other liquids.
5. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the appliance.
Children are not always able to understand potential risks. Teach children a responsible
handling of electrical appliances.
7. Check that the cord is not hanging over the edge of the table.
8. Do not place the appliance on or near hotplates, open fire or the like.
9. The appliance should only be used under supervision.
10. Be careful when sharpening knives. Ensure that only the blade of the knife gets in contact
with the rotating abrasive wheel.
11. Never put fingers in to the rotating abrasive wheel.
12. Always examine appliance, cord and plug for damage before use. If the supply cord is
damaged, it must be replaced by the manufacturer, or his service agent or a similarly
qualified person in order to avoid a hazard.
13. The electrical installation must comply with the present legislation concerning additional
protection in the form of a residual current device (RCD) with a rated residual operating
current not exceeding 30 mA). Check with your installer.
14. The appliance is for domestic use only.
17