Sonesse 28 WF RTS ORIGINAL INSTRUCTIONS These instructions apply to all Sonesse 28 WF RTS drives, the different versions of which are available in the current catalogue. CONTENTS 1. Prior information................... 1.1. Field of application................1.2. Liability ....................2. Installation......................
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and invalidates the warranty.
Make sure that LED, programming button and input connection remain visible and easily accessible after installation. 2.1.Assembly 2.1.1.Preparing the drive CAUTION Sonesse 28 WF RTS : interior diameter of the tube has to be Ø26.6 mm or greater. 1] Fit the crown (a) and drive wheel (b) to the motor. (a)(b) 2] Measure the length (L) between the end of the drive wheel and the head end.
2] Quickly press the Prog. button (B) on the control point to add or delete. g Green LED blinks 5 times. NOTICE Other functions are available, for more information, contact your Somfy representative. 4.TECHNICAL DATA Power supply 12 Vdc SELV Radio frequency 433.42 MHz...
Page 20
Sonesse 28 WF RTS SOMFY ACTIVITES SA, F-74300 CLUSES as manufacturer hereby declares that the drive covered by these instructions and used as intended according to these instructions is in compliance with the essential requirements of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC, and the Radio Directive 2014/53/EU.