Download Print this page

HON 105 Stack-On Unit Manual page 4

Advertisement

Available languages

Available languages

Illustration 9
Hinge
_
Post
Mounting
plate
Detail A
Illustration 10
Center stack-on unit
Side-to-side
Side-to-side positioning
Illustration 11
Mounting tape
4 OF 5
105 Stack-On Unit
Hinge slot
J Hook
Detail B
Front-to-rear
positioning
9. Refer to Illustration 9. Attach door, with hinges, to stack-
on.
Refer to Detail A. Locate the post on the mounting
plate and the "J" hooks beneath the hinge arm.
Refer to Detail B. Gently rotate the door in the direc-
tion of the mounting plate, then press lightly on the
end of the arm to engage the catch.
Repeat this procedure for remaining door.
Stack-On Installation:
Ensure all assembly requirements have been properly
completed. Read all of the following instructions before
proceeding. Mounting surface of shell desk must be
clean and free of any wax or oil residue.
Do not remove protective cover on mounting tape until
instructed to.
1. Refer to Illustration 10. Use two or more people to
position stack-on unit onto desk/credenza. Unit should
be flush at rear and be centered from side-to-side. DO
NOT remove protective cover from mounting tape
on bottom edge of end panels.
2. After aligning stack-on unit, place masking tape on top
of desk/credenza to mark each end panel position.
Mounting tape used to secure stack-on unit is extreme-
ly sensitive and is designed to be a permanent instal-
lation. Attempting to remove stack-on unit will cause
severe damage to surface of desk/credenza.
3. Refer to Illustration 11. Lift one end of stack-on unit
up approximately 3". Be especially careful not to apply
any pressure which may cause the opposite end of
stack-on unit to slip off desk/credenza.
4. While stack-on unit is raised, remove protective cover
from mounting tape. While maintaining alignment,
carefully lower stack-on unit and realign end panel with
masking tape. Repeat this procedure for remaining
end panel.
Approx. 3"
Do not lean on, bump, or load storage shelf of this
stack-on unit for a period of 12 hours minimum
after the mounting tape has been in contact with
desk/credenza. Do not use unit without the mount-
ing tape. Failure to follow this warning can cause
the stack-on unit to tip and fall, resulting in severe
injury to yourself or others.
IMPORTANT
IMPORTANT
WARNING
242-9641C
www.hon.com

Advertisement

loading

Related Products for HON 105 Stack-On Unit