HON 105 Stack-On Unit Manual page 3

Illustration 7
Wood screw
Illustration 8A - Glass Door
Door
Illustration 8B - Wood Door
Door
242-9641C
www.hon.com
105 Stack-On Unit
Hinge
Hinge
mounting
hole
6. Refer to Illustration 7. Position two corner brackets
(from hardware pack) against the bottom of top assem-
bly and against each end panel as shown.
Always wear eye protection when using power tools.
Use the drill and
Corner
bracket screws (from hardware pack) through each corner
bracket and into end panels and top assembly. Fully
tighten wood screws.
7. Refer to Illustration 8A. Locate hinge mounting holes on
Hinge screw
rear of door. Lay door, with hinge mounting holes up,
on cardboard or a carpeted surface.
Use the phillips screwdriver to install two hinge screws
(from hardware pack) through hinge and onto door as
shown.
Repeat this procedure for remaining door.
8. Refer to Illustration 8B. Locate hinge mounting holes on
Hinge
rear of door. Lay door, with hinge mounting holes up,
on cardboard or a carpeted surface.
Use the rubber mallet to install two hinges (from hard-
ware pack) onto door as shown. Align hinges with hinge
mounting holes and carefully tap hinges into place.
Repeat this procedure for remaining door.
Hinge
mounting
hole
/ " power nutdriver to install four wood
1
4
3 OF 5