HON 105 Stack-On Unit Manual page 2

Illustration 4
Minifix bolt
Shoulder
Illustration 5
End panel
Hole
Illustration 6
Bottom of top
assembly
Minifix
cam
Top
2 OF 5
105 Stack-On Unit
Reveal
Dowel
Side of top assembly
Top assembly
Minifix bolt
Minifix cam
End panel
Interior wall of
top assembly
Arrow
3. Refer to Illustration 4. Place a reveal onto two dowels
along side of top assembly. Position reveal so that
edge of reveal is flush with edge of top.
Use the Phillips screwdriver to install two minifix bolts
(from hardware pack) through reveal and into top.
Tighten each minifix bolt until minifix bolt shoulder is
flush against surface of reveal.
Repeat this procedure for opposite end of top assembly.
4. Refer to Illustration 5. With dowels and minifix bolts fac-
ing top assembly, install end panels by inserting ends
of minifix bolts, installed in top assembly, into holes
drilled along top edges of end panels.
Pivot end panels toward top assembly and insert end
panel dowels and minifix bolts into holes drilled into sides
of top assembly.
5. Refer to Illustration 6. With arrows facing top, install
minifix cams (from hardware pack) into holes in interior
wall of each end panel. Use the Phillips screwdriver to
tighten minifix cams. Turn minifix cams clockwise to
tighten.
With arrow facing end panel, install minifix cam (from
hardware pack) into hole in bottom of top asssembly.
Use the Phillips screwdriver to tighten minifix cam. Turn
minifix cam clockwise to tighten.
242-9641C
www.hon.com