Setting Wall Oven - Frigidaire PLEB30M9EC Use & Care Manual

Setting the Clock
The Clock pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the range
is first plugged in, or when the power supply to the range has been interrupted, the timer in
the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press
but after 10 seconds a beep will sound and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press Clock . "CLO" will appear in the display (Figure 2).
1 3 0
2. Press pads to set the time of day to 1:30 (Figure 3).
"CLO" will stay in the display. Press
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold Clock
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display
and the control will beep once.
2. Press to switch between the 12 and 24 hour time of day
Clean
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
START
3. Press to accept the change or press
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Setting Wall Oven Controls
START
. "CLO" will disappear
for 7 seconds (Figure 3). After 7 seconds,
Clear
No sound will be heard,
.
/Off
Clock
Clear
to reject the
/Off
18
PRESS
Clock
1 3 0
START
for 7 seconds
Clean
Clear
START
or
/Off
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6