Table of Contents
Advertisement
PREPARATION
ASSEMBLING THE DETECTOR
Assembling your detector is easy and requires no special tools. Just follow these
steps.
1. Turn the stem's lock nut clockwise until it loosens.
2. Lengthen or shorten the stem so when you stand upright with the detector in
your hand, the search coil is sitting level with the ground, about 1/2 to 2 inches
above the ground with your arm relaxed at your side.
3. Turn the stem's lock nut counter-clockwise to lock it in place.
4. Unscrew the knob on the search coil and remove the knob connector. Insert
the stem and align the holes on the search coil bracket and the stem. Push
the connector through the holes, then retighten the knob.
5. Wind the search coil cable around the stem. Leave enough slack in the cable.
6. Insert the search coil's plug into the search coil jack on the detector's control
housing.
Caution:
The search coil's plug fits into the connector only one way. Do not force the
plug or you could damage it.
3
Advertisement
Table of Contents
