Kogan KAMETANDETA User Manual page 10

Notes:
If there are interference from other instruments, electrical cables, TVs or

radio in your searching area, set the FREQ ADJ to another position or lower
the sensitivity. If this does not help, you may need to move to a different
search area.
When searching in highly mineralized areas, the unit will sound even if

there's no metal. In this case, you can lower the sensitivity and increase the
height between the search coil and the ground until the false signal
disappears. If necessary, you may need to reset the DISC/TONE.
When searching in a trash filled area, it's better to set the DISC/TONE to 5

position, so that the unit can ignore most invaluable metals such as nails
and small trashy iron.
Keep metal digging tools away when searching.

You can search for all metal targets with "Target Pin-pointing". If you're

searching for small targets near where a large metal object is buried, a false
signal will appear. In this case, remove the large metal object.
Sensitivity levels are generally in contradiction with that of the level of

discrimination. The higher the sensitivity level is, the worse discrimination
performance will be. You can lower the sensitivity to have better
discrimination between metals.
You can move the search coil horizontally and vertically and make a cross at

the sound point.
10