Table of Contents
Advertisement
C. DISC/TONE
You can set the mode switch to any desired position from rotating it from
"0"~"10". When in DISC mode, the detector discriminates the metal type
according to the length of the tone it sounds. When in TONE mode, the
detector discriminates the metal type as per the volume of the tone.
D. Target Pinpointing
Press the red button at the top of the handle to lower the sensitivity in order to
pin-point targets more accurately.
E. PHONE jack
Connect earphones to the
disconnected.
F. SENSITIVITY.
Turn to any position from "0" to "10". Get lowest sensitivity in "0" position and
highest sensitivity in "10" position. Turn SENSITIVITY to a higher position when
searching targets; Turn SENSITIVITY to a lower position when searching in
highly mineralized soil or a high electronic interference area and the metal
detector is not working stably.
G. FREQ ADJUST
Adjust sensitivity with FREQ ADJUST to avoid interference from any other metal
detectors in the same area.
H. LOW BATTERY
The LOW BATTERY indicator lights to indicate it's time for user to replace the
batteries.
I. Analog Meter
When the metal detector finds a metal target, the meter pointer will turn right.
PHONE jack
, and the speaker inside will be
7
Advertisement
Table of Contents
