Kogan KAMETANDETA User Manual
  1. Manuals
  2. Brands
  3. Kogan Manuals
  4. Metal Detector
  5. KAMETANDETA
  6. User manual

Kogan KAMETANDETA User Manual

Deep target waterproof metal detector
Hide thumbs Also See for KAMETANDETA:
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading

Related Manuals for Kogan KAMETANDETA

Summary of Contents for Kogan KAMETANDETA

  • Page 2 Using the metal detector, you can hunt for coins, relics, jewelry, gold, and silver just about anywhere. The detector is versatile and easy to use. The detector’s features include: Targeting - pinpoint the target accurately by lowering the sensitivity. Tone - distinctive sound tones to differentiate between types of metal. All Metal - search for all kinds of metal objects.

  • Page 3: Assembling The Detector

    PREPARATION ASSEMBLING THE DETECTOR Assembling your detector is easy and requires no special tools. Just follow these steps. 1. Turn the stem’s lock nut clockwise until it loosens. 2. Lengthen or shorten the stem so when you stand upright with the detector in your hand, the search coil is sitting level with the ground, about 1/2 to 2 inches above the ground with your arm relaxed at your side.

  • Page 4: Installing The Batteries

    7. Loosen the knob at the search coil’s end, then adjust the search coil to the desired angle so that it is parallel with the ground. Then retighten the knob. Caution: Do not overtighten the search coil or use tools such as pliers to tighten it. 8.

  • Page 5: Using Headphones

    USING HEADPHONES 1. Insert the headphones’ 3.5mm plug into the HEADPHONE jack. At this time the internal speaker disconnects. 2. Set the VOLUME to the desired setting. headphone Listening Safely To protect your hearing, set the volume to the lowest setting before you ...

  • Page 6: A Quick Look At The Detector

    A QUICK LOOK AT THE DETECTOR Analog Meter Mode Switch LOW BATTERY FREQ ADJUST VOLUME DISC/TONE SENSITIVITY Target Pin-Pointing PHONE CONTROLS & INDICATORS A. Operating Modes “OFF” - Power off.  “DISC” - Discrimination mode. Works with DISC/TONE. Discriminates the ...

  • Page 7: Phone Jack

    C. DISC/TONE You can set the mode switch to any desired position from rotating it from “0”~”10”. When in DISC mode, the detector discriminates the metal type according to the length of the tone it sounds. When in TONE mode, the detector discriminates the metal type as per the volume of the tone.

  • Page 8: Target Pinpointing

    4. Operation Your metal detector has four operation modes: DISC, TONE, ALL METAL and TARGET TRACK. DISC and TONE are motion modes while TARGET TRACK is a non-motion mode. When searching, generally set operation mode to “DISC” and to high sensitivity position and set “DISC/TONE”...

  • Page 9: All Metal

    away from the search coil). In this case, put the search coil closer to the earth and you’ll hear the sound again. Repeat the above steps until you find the target. After you find the target, make a choice from the following three operating modes to determine which kind of metal the target is.
  • Page 10 Notes: If there are interference from other instruments, electrical cables, TVs or  radio in your searching area, set the FREQ ADJ to another position or lower the sensitivity. If this does not help, you may need to move to a different search area.

  • Page 11: Care And Maintenance

    CARE AND MAINTENANCE Your metal detector is an example of superior design and craftsmanship. The following suggestions will help you care for your metal detector so you can enjoy it for years. Handle the detector gently and carefully. Dropping it can damage circuit boards and cases and can cause the detector to work improperly.

Table of Contents