Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Kogan KAMATANDETA
Summary of Contents for Kogan KAMATANDETA
- Page 2 With your metal detector, you can hunt for coins, relics, jewelery, gold, and silver just about anywhere. The detector is versatile and easy to use. Its features include: Targeting Pinpoint the target accurately by lowering the sensitivity. Tone Utilise distinctive tones to identify different types of metal. All Metal Search for a diverse range of metal objects.
-
Page 3: Assembling The Detector
Low Battery Indicator You'll know exactly when you need to replace the detector's batteries. Power Your metal detector requires 2 x 9-volt alkaline batteries (not supplied). The built in DC—DC circuit can avoid wrong battery polarity connection and prolong battery life. - PREPARATION - ASSEMBLING THE DETECTOR Assembling your detector is easy and requires no special tools. - Page 4 Caution: The search coil’s plug fits into the connector only one way. Do not force the plug or you could damage it. Loosen the knob at the search coil’s end, then adjust the search coil to the desired angle so that it is parallel with the ground. Then tighten the knob. Caution: Do not overtighten the search coil or use tools such as pliers to tighten it.
-
Page 5: Installing The Batteries
INSTALLING THE BATTERIES Cautions: Use only fresh alkaline batteries of required size. Do not mix the old and new batteries or different types of batteries. 1. Set the switch to OFF. 2. Slide the left and right battery covers off in the direction of the arrows. 3. -
Page 6: Using Headphones
USING HEADPHONES 1. Insert the headphones’ 3.5mm plug into the HEADPHONE jack. Upon doing so, the internal speaker will disconnect. 2. Set the VOLUME to the desired setting. Listening Safely To protect your hearing, set the volume to the lowest setting before you ... -
Page 7: A Quick Look At The Detector
A QUICK LOOK AT THE DETECTOR... -
Page 8: Controls And Indicators
CONTROLS & INDICATORS A. Operating Modes “OFF” - Power off. “DISC”- Discrimination mode. Works with DISC/TONE. Discriminates the metal type based on the tone. TONE - Works with DISC/TONE. Sounds two different tones for different types of metal. ALL METAL- In this mode, the detector can detect all kinds of metal with ... - Page 9 F. SENSITIVITY. Turn to any position from “0” to “10”. The lowest sensitivity is represented with “0” and the maximum sensitivity with “10”. Turn SENSITIVITY to a higher position when searching targets; Turn SENSITIVITY to a lower position when searching in highly-mineralized soil or high electronic interference areas. G.
- Page 10 Operation Your metal detector has four operation modes: DISC, TONE, ALL METAL and TARGET TRACK. DISC and TONE are motion modes while TARGET TRACK is a non-motion mode. When searching, generally set “DISC” as the operation mode, with high sensitivity and “DISC/TONE” set to “0”. Sweep your search coil as demonstrated in the picture below, moving the search coil back and forth in an arc.
-
Page 11: Target Pinpointing
TARGET PINPOINTING If there is a sound of “di-di” during searching in DISC, it indicates that there is a metal target in the sound area. In this case, you can use “TARGET PINPOINTING” to pin-point the target. Hold the search coil 50cm or more away from the earth. -
Page 12: All Metal
tones will represent copper. A high tone indicates silver. Practice with the metal detector is required to ensure accurate detection. Be sure to make notes during practice. ALL METAL Set the mode switch to ALL METAL and the DISC/TONE to any position. The unit will respond with a tone to all metal. -
Page 13: Care And Maintenance
CARE AND MAINTENANCE Your metal detector is an example of superior design and craftsmanship. The following suggestions will help you care for your metal detector so you can enjoy it for years. Handle the detector gently and carefully. Dropping it can damage circuit boards and cases.