Assembling The Detector - Kogan KAMATANDETA User Manual

Low Battery Indicator
You'll know exactly when you need to replace the detector's batteries.
Power
Your metal detector requires 2 x 9-volt alkaline batteries (not supplied). The built
in DC—DC circuit can avoid wrong battery polarity connection and prolong
battery life.
- PREPARATION -

ASSEMBLING THE DETECTOR

Assembling your detector is easy and requires no special tools. Just follow these
steps.
Turn the stem's lock nut clockwise until it loosens.
•
• Lengthen or shorten the detector so that when you hold it and stand
upright, the search coil is level about 1/2 to 2 inches above the ground
and your arm can relax at your side.
Turn the stem's lock nut counter-clockwise to lock it into place.
•
Unscrew the knob on the search coil and remove the knob connector.
•
Insert the stem and align the holes on the search coil bracket and the
stem. Push the connector through the holes and tighten the knob.
Wind the search coil cable around the stem. Leave enough slack in the
•
cable.
Insert the search coil's plug into the search coil jack on the detector's
•
control housing.