Ariston Nuos PRIMO 80 Manual page 30

1.5 Packaging and supplied accessories
The device consists of an external unit (heat pump) and an internal one (water heater), this could be anchored to a
wooden pallet (only 300L model), Both units are protected by polystyrene buffers and cardboard on the outside; all the
materials are recyclable and eco-compatible.
The following accessories are included:
- Shielded probe connection cable between units;
- Connection pipe for condensation water of the external unit;
- Drainage pipe for condensation water;
- Wall hole protection;
- Instruction manual and warranty documents;
- One 3/4" dielectric coupling.
- Rubber grommets and cable clips with screws.
1.6 Transport and handling
Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of
damage appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! Absolutely imperative that the external unit is handled and stored in an upright position, with the
aim of ensuring adequate provision of oil inside the cooling system and avoid damage to the compressor.
The indoor unit can be moved both vertically and horizontally.
The packaged unit can be moved by hand or with forklift trucks, taking care to respect the directions above. It is
recommended to keep the product in its original packaging until you install it in the selected area, particularly in the
case of a construction site.
After unpacking, check for accuracy and completeness of the supply. In case of non-compliance, please contact the
seller, taking care to make a communication within the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication
concerning the allowed tilt angle of the external unit, and ensure that all water has been drained from the tank. If the
original packaging missing, provide an adequate protection for the appliance to prevent any damages, for which the
manufacturer shall not be held liable.
1.7 Identification of the appliance
The main information for identifying the appliance is contained on the adhesive data plate located on the water heater
casing.
Internal unit technical label
Heat pump water heater – GENERAL INFORMATION
A model
B tank capacity
C serial no.
D power supply voltage. frequency. maximum absorbed power
E max./min. pressure of the refrigeration circuit
F tank protection
G absorbed power – heating element mode
H marks and symbols
I thermal power yielded in heat pump mode
L max./min. power in heat pump mode
M type of refrigerant and charge
N maximum tank pressure
28
Description