Organized Living freedomRail Garage Assembly Instructions

Contents of Package

Left Side

Tools Required

Power Drill

Assembling the 1 Shelf GOBox

Step 1: Attach Hanging Brackets

Left Side
Back Edge
Attach Hanging Brackets to Sides using Euroscrews. (If using Power Drill, set torque to low setting.)

Step 3: Attach Sides

Lock
(a) Attach Sides and Verticals to Bottom. (b) Lock Cams by turning clockwise until snug.
(a) Attach Sides to Bottom. (b) Tighten Cams by turning clockwise until snug.
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
freedomRail Garage Assembly Instructions
1 Shelf GOBox
Backing
Right Side
#2 Phillips Driver
#2 Phillips
Screwdriver
Cam
Open
Hammer
Right Side
Back Edge

Step 4: Attach Top

(a) Attach Top. (b) Lock Cams by turning clockwise until snug.
(a) Attach Top. (b) Tighten Cams by turning clockwise until snug.
Over
Shelf
Top and Bottom

Step 2: Install Connector Bolts

Top and Bottom
Smaller Holes for
Connector Bolts
Install (4) Connector Bolts into small holes on Top and Bottom Panels.
(20) Euroscrews
(16) Backing Nails
(8)
Connector Bolts
(4)
Hanging
Brackets
Shelf
(4)
Screws
Top
1