Organized Living freedomRail Doors for GOLocker Assembly Instructions

Contents of Package
Installing the Doors
Step 1: Attach Two Hinge Assemblies
to Each Door
Press Cup into large hole.
Align screw holes. Insert and tighten wood screws.
Step 3: Attach Hinge Assembly and Door
to Hinge Plates in the Cabinet.
(a) Attach Hinge Assembly into Hinge Plates (See Detail A).
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
freedomRail Garage Assembly Instructions
Doors for GOLocker
(2) Doors
(4)
(2) Handles
Step 2: Install 2 Hinge Plates on Each Side of Cabinet
Place Hinge Plate into Cabinet by aligning Euro Screws with Top and Bottom
Pairs of Holes. Tighten Euro Screws to secure Hinge Plate.
Detail A Top View
Hinge Plate on GOBox
(4) Soft Close Hinge Assembly
1" Machine Screws
and Hinge Plates
(For Handles)
Hinge Assembly and Door
Over
Tools Required
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
Snap
(b) Rotate Hinge Assembly until it snaps into
place. NOTE: Depending on the installation of the
Doors, there will be (2) holes at the top left or
bottom right corner of the Door.
1