New Holland 200 Series Service Manual page 24

PIPE THREAD FITTING TORQUE
Before installing and tightening pipe fittings, clean the
threads with a clean solvent or Loctite cleaner and ap-
ply sealant for all fittings including stainless steel or for
most metal fittings. For high filtration/zero contamination
systems use .
INSTALLATION OF ORFS (O-RING FLAT
FACED) FITTINGS
When installing ORFS fittings thoroughly clean both flat
surfaces of the fittings (1) and lubricate the O-ring (2) with
light oil. Make sure both surfaces are aligned properly.
Torque the fitting to specified torque listed throughout the
repair manual.
NOTICE: If the fitting surfaces are not properly cleaned,
the O-ring will not seal properly. If the fitting surfaces are
not properly aligned, the fittings may be damaged and will
not seal properly.
NOTICE: Always use genuine factory replacement oils
and filters to ensure proper lubrication and filtration of en-
gine and hydraulic system oils.
The use of proper oils, grease, and keeping the hydraulic
system clean will extend machine and component life.
INTRODUCTION
Thread Size
1/8-27
1/4-18
3/8-18
1/2-14
3/4-14
48068128 29/01/2018
17
PIPE THREAD FITTING
Torque (Maximum)
13 N·m (10 lb ft)
16 N·m (12 lb ft)
22 N·m (16 lb ft)
41 N·m (30 lb ft)
54 N·m (40 lb ft)
2
50011183