New Holland 200 Series Service Manual page 16

7. Slowly raise the loader arm until the support strut (B)
falls onto the cylinder rod (D).
8. Stop the engine.
9. Pull up on the override control knob (red control knob
near the right-hand side of the operator's seat). The
support strut (B) will brace against the top of the cylin-
der barrel (C)..
10. Ask an assistant to insert the pin (A) into the support
strut (B). If an assistant is not available visually con-
firm that the support strut is braced against the top of
the cylinder barrel before exiting the machine.
Tilt and lock the cab forward for machine service
1. Remove the two, rear retaining nuts, located at the
rear of the cab.
INTRODUCTION
48068128 29/01/2018
9
3
93106854A
4
RAIL14SSL0418AA
5
931001633