New Holland 200 Series Service Manual page 20

6. Locate the loader arm lock lever on the left-hand side
of the operator's seat.
7. Rotate the lock lever toward the operator's seat (clock-
wise) to engage the lock support pin(s).
8. Stop the engine.
9. Pull up on the override control knob (red control knob
near the right-hand side of the operator's seat). The
loader will brace against the lock support pin and keep
the loader arm in a raised position.
NOTE: Only use the override control knob to lower the
loader arm in emergency situations when engine power
is not available or to lower it onto the lock support pin for
servicing the machine.
Tilt and lock the cab forward for machine service
1. Remove the two, rear retaining nuts, located at the
rear of the cab.
INTRODUCTION
48068128 29/01/2018
13
3
RAIL14SSL0427AA
4
93107457
5
931001633