Table of Contents
Advertisement
Explorer 107 Operation and Maintenance Manual
Lower the shield
a) Pull both safety latches on the front safety
shield toward the center of the laminator
and lower.
b) Align the safety latches with their respective
interlocks and slide the safety latches
outwards.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
© GBC Pro - Tech December 1999
5.9 Pressure plate
INFORMATION
Safety latches on the pressure plate are
not associated with an interlock switch.
The laminator will operate without
the pressure plate installed.
The pressure plate is provided to assist with
keeping the leading edge and trailing edge of a print
flat.
Removing the pressure plate
Caution should always be exercised
when using the laminator with
the safety shield raised.
You can be seriously HURT or INJURED!
a) Pull both safety latches on the front safety
shield toward the center of the laminator.
Operations
WARNING
Page 5 - 25
Advertisement
Table of Contents
