Advertisement
• Connect to 2-1/4" ID tool port - Connect one end of a
2-1/2" ID polypropylene hose directly to the Cyclone dust
port and secure with the 2-3/4" hose clamp. Using a quick
change coupler, connect the other end of the hose directly
to the 2-1/4" ID machine port.
Figure 7
2-3/4" Hose
Clamp
• Connect to small tool dust port – Use the 2-1/4" end of
the 2-1/4" to 1-1/2' adapter to connect directly to the Cyclone
dust port and the 1-1/2" OD end to the 1-1/2" ID end of a
small hose kit, similar to Powertec 70175.
Figure 8
NOTE: The 2-1/2" ID polypropylene hose can also be
connected directly to either port of the Cyclone Dust Collection
System by using the 2-3/4" hose clamp.
NOTE: Empty the bucket when the debris reaches the
FULL LINE for maximum performance. See Figure 3.
• Adjust the casters – The casters are attached to the
bottom of the bucket with M12 nuts and can be adjusted to
match the work surface .
- Use a M12 wrench to loosen the nut on the bottom of
the bucket.
- Move the nut up or down to the proper height.
- Hold the M12 nut on the inside of the bucket while
tightening the M12 nut on the bottom of the bucket.
- Repeat on the other casters if needed.
2-1/4" to 2-1/2"
Quick Connect
Coupler
Dust
Port
2-1/4" to 1-1/2"
Reducer
1-1/2" ID Small
Hose
Power Tool
Advertisement
