Advertisement
INSTALLATION
Refer to Figure 2 to 8
1.
Place the bucket lid upside down and attach the elbow to
one of the holes in the lid. Make sure the elbow is oriented
as shown in Figure 1 and does not face the other hole.
Figure 2
2-1/2"
Elbow
2.
Place the lid onto the plastic bucket.
Figure 3
3.
Connect the system to a shop vacuum or dust collector.
The shop vacuum or dust collector MUST be connected to
the dust port WITHOUT the elbow.
a.
Connect to a shop vacuum with a 2-1/4" ID port:
• Thread a quick connect coupler onto one of the
2-1/2" ID polypropylene hoses. IMPORTANT: When
connecting the hose to the quick connect
coupler, the end of the hose MUST be extended
in order to thread into the left handed threads of
the coupler.
• Connect the coupler to the dust port on the lid
without the elbow.
• Thread a second quick connect coupler into the
other end of the polypropylene hose and connect
the 2-1/4" OD end into the shop vacuum port.
Figure 4
2-1/4" to 2-1/2"
Quick Connect
Coupler
Shop
Vacuum
2-1/2" ID
Polypropylene
Hose
Figure 5
Underside of 12"
two stage cyclone
separator lid
The kit comes with a variety of components
that can be configured to perform several
types of connections. Make these
connections after the Cyclone Dust
Collection System is connected to the shop
vacuum or dust collector. Here are
some examples.
• Connect to 2-1/2" OD port – Connect one end of a
2-1/2" ID polypropylene hose directly to a 2-1/2" OD
machine port and secure with the 2-3/4" hose clamp. Using
a quick change coupler, connect the other end of the hose
directly to the Cyclone dust port.
Figure 6
2-1/4" to 2-1/2"
Quick Connect
Coupler
b.
Connect to a dust collector:
• Connect the 4" to 2-1/2" reducer to a dust collector
hose with the 4-1/4" hose clamp.
• Connect the 4" to 2-1/2" reducer to the dust port on
the lid without the elbow.
Dust
Collector
Shop
Vacuum
Dust Collector
Hose
2-1/4" to
2-1/2"
Quick
Connect
Coupler
4-1/2" Hose
Clamp
4" to 2-1/2"
Reducer
2-3/4"
Hose
Clamp
Dust
Port
Advertisement
