Kaba Simplex 1000 Series Faq page 2

Resetting the code / combination from a lost code

Hide thumbs Also See for Simplex 1000 Series:

Access Control - 1000 Series PBL FAQ

10. Return the unlocking slide (C) over the unlocking slide stud

(A) while making certain the five toes (G) are engaged in the five

gear pockets (F). It may be necessary to adjust each gear slightly

to make proper alignment between toes and gear pockets (see

figures 6 & 7). Resecure the "e" ring (B) on the unlocking slide

stud (A). Your chamber will now resemble figure 7. and is ready

for reassembly into the lock housing.

REASSEMBLY

1. Resecure the chamber cover (A). Make sure the staked joints

(B) on both end plates fit through both slots on the back cover

(see figure 2).

2. Resecure the shaft bushing (C) with flat side facing up (see

figure 1).

3. Secure the combination chamber (D) with the two Phillips head

screws (E) you removed earlier (see figure 1).

4. Resecure the chamber linkage (A) onto the control shaft (B)

(see figure 1).

5. Resecure the back plate and secure it with the six back plate

screws.

SETTING THE COMBINATION

Do not attempt to set a combination until the complete unit has

been reassembled. Perform the following steps in the order shown.

1. Turn the outside knob once clockwise to the stop position and

then release.

2. Enter the new combination.

3. Turn the outside knob clockwise to the stop position, make sure

the latch is fully retracted, then release the knob.

4. Repeat steps 2 & 3 before closing your door to confirm code

setting.

PRINT THIS SECTION

http://www.kaba-ilco.com/access_control/support/pbl_faq/resetting_code_combination/1000_series.asp (2 of 2) [5/21/2004 11:11:14 AM]