Getting Started; Loading The Printer - U-Line H-2526 Manual

GETTING STARTED

1. Make sure the power switch is in the OFF position
(down). (See Figure 1)
2. Insert the AC power cord into the power supply.
(See Figure 1)
Printer
Power Receptacle

LOADING THE PRINTER

1. Open the printer. Pull the release latch levers toward
the front of the printer. (See Figure 2)
2. Open the media roll holders. Pull the media guides
open with your free hand and place the media roll
on the roll holders and release the guides.
(See Figure 2)
3. Orient the media roll so that its printing surface will
face up as it passes over the platen roller.
(See Figure 2)
PAGE 2 OF 18
ASSEMBLY
3. Plug the other end of the cord into an appropriate
4. Insert the power supply's power connector into the
Plug (Varies by Country)
Power Switch
Power Connector
Active Power Light
Media Roll Holders
Release Latch Levers
Platen Roller
AC electrical outlet.
Note: The active power light will go on if power
is on at the AC outlet. (See Figure 1)
printer's power receptacle. (See Figure 1)
Power Supply
IEC 60320 C-13
Figure 2
Media Roll
Figure 1
AC Power Cord
0517 IH-2526