U-Line H-2526 Quick Start Manual

π
H-2526, H-2550
ZEBRA BAR CODE
PRINTER
LED STATUS AND COLOR
OFF
SOLID GREEN
SOLID AMBER
FLASHING GREEN
FLASHING RED
DOUBLE FLASHING GREEN
FLASHING AMBER
ALTERNATELY FLASHING
GREEN AND RED
FLASHING RED, RED AND
GREEN
PAGE 1 OF 2
1-800-295-5510
uline.com
TROUBLESHOOTING
PRINTER STATUS
The printer is not receiving power:
• Turn off the power.
OFF • Check power connection from the outlet to the power supply, and from the
power supply to the printer.
• Disconnect the printer from the outlet for 30 seconds and then reconnect.
The printer is on and in an idle state:
ON
• No action necessary.
The printer has failed its power on self test (POST)
• If this error occurs right after power is turned on, contact an authorized reseller
for assistance.
STOPPED • When the printer is operating normally, the printer status light will be amber for
about 10 seconds before turning green (solid or blinking).
There is a memory error:
• Turn power off and on, and then resume printing.
The printer is receiving data:
NORMAL OPERATION • As soon as all data has been received, the status LED will turn green and the
printer will automatically resume operation.
The media is out:
• Follow the instruction for loading the media roll, and then press the feed
button to resume printing.
STOPPED The ribbon is out:
• The printer has sensed the end of the ribbon roll. Replace the ribbon.
The printhead is open:
• Close the top cover and press the feed button to resume printing.
The printer is paused:
PAUSED
• Press the feed button to resume printing.
The printhead is over temperature:
• Printing will stop until the printhead cools to an acceptable temperature.
PAUSED
• The printer will automatically resume operation.
FLASH memory is not programmed:
NEEDS SERVICE
• Return the printer to an authorized reseller.
Printhead or motor has had a critical failure:
NEEDS SERVICE
• Return the printer to an authorized reseller.
RESOLUTION
0315 TH-2526