Table of Contents
Advertisement
3
/
" Screws
4
Side Support
• Position the side support on a flat surface.
• Insert four
3
/
" screws into the side support. Tighten the screws
4
with a Phillips screwdriver. Do not over-tighten.
Top Floor
Square Opening
Post
Upper
Crossbar
• Fit the square openings on the underside of the top floor onto
the posts on the side support.
• Make sure the rectangular tab on the top floor inserts into the
rectangular opening on the side support upper crossbar.
• Push down firmly on the top floor to snap it onto the side
support.
Helpful Hint: You may need to push down near each of the posts
and the tab to fully snap each one into the side support. You will
hear a "click" when each post and the tab snaps into the side
support.
• Pull up on the top floor to make sure it is secured to the side
support.
3
/
" Screws
4
End Tab
Opening
• Insert the middle tab on the center floor into the opening in the
side support lower crossbar.
• Insert the end tabs on the center floor into the openings in the
side support legs.
• Push down firmly on the center floor to snap it into the side
support.
Rectangular
Helpful Hint: You may need to push down near each of the three
Tab
tabs to snap each one into the side support. You will hear a
"click" when each tab snaps into the side support.
• Pull up on the center floor to make sure it is secured to the side
support.
• Set the side support assembly aside.
Square Opening
Post
Rectangular
Opening
Elevator
Towers
Side
Support
• Place the elevator tower with the rails on a flat surface, with the
rails facing up.
• Place the other elevator tower on the flat surface, as shown.
• Insert two 1" screws into each elevator tower, as shown.
Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• With the elevator at an angle, fit the grooves in the elevator
onto the rails at the bottom of the elevator tower
• Rotate the elevator down
grooves onto the elevator tower rails.
• Slide the elevator to the middle of the elevator tower
4
Center Floor
Side
Support
Lower
Leg
Crossbar
1" Screws
Rails
1" Screws
2
Middle
Tab
End Tab
Opening
Opening
Elevator
1
3
Bottom of
Elevator
Tower
1
.
to fully seat the
.
3
2
Advertisement
Table of Contents
