Table of Contents
Advertisement
Rectangular
Opening
Rectangular
Tab
Elevator
Tower
• Stand both elevator towers upright, as shown. The short,
rectangular tabs are at the top of the elevator towers.
• Fit the tower roof onto the elevator towers.
• Push down firmly near each of the rectangular tabs to snap the
tower roof onto the elevator towers. You will hear a "click" when
each tab snaps into the tower roof.
• Pull up on the tower roof to make sure it is secured to the
elevator towers.
Top Floor
Center Floor
• Insert and firmly snap the tabs on the top and center floors into
the rectangular openings in the sides of the elevator tower. You
will hear a "click" when each tab snaps into the elevator tower.
• Pull on the elevator tower to make sure it is secured to the top
and center floor.
Tower Roof
Rectangular
Opening
Rectangular
Tab
Elevator
Tower
Elevator Tower
Tabs
Tabs
Rectangular
Openings
Rectangular
Openings
Tabs
Rectangular
Openings
Side
Support
Tabs
• Turn the assembly so that the side support faces you.
• Insert and firmly snap the tabs on the ends of a spiral ramp into
the rectangular openings in the center floor.
• Insert and firmly snap the tabs on the ends of the other
spiral ramp into the rectangular openings in the top floor.
• Pull on each spiral ramp to make sure it is secured to the top or
center floor.
Top Floor
3
/
"
4
Screws
Spiral Ramp
• Lay the assembly on its side with the bottom facing you.
• Insert the connector tube up through the U-shaped rings on the
ends of the upper and lower spiral ramps.
• Insert the top of the connector tube into the recess in the top
floor.
• Insert a
3
/
" screw through each spiral ramp and into the side
4
support, as shown. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• Turn the assembly upright.
5
Top Floor
Side View
Recess
Bottom View
Spiral
Ramps
Center
Floor
U-Shaped
Rings
Connector
Tube
Advertisement
Table of Contents
