Seat Back
12
FRONT VIEW
•
Place the seat back onto the vehicle, as shown.
13
TOP VIEW
•
Insert three screws into the holes in the seat back
and tighten.
Roll Bar
14
FRONT VIEW
•
Fit the tabs on the roll bar onto the seat back and
vehicle, as shown.
ASSEMBLY
Screws
15
•
Insert four screws into the holes in the roll bar
and tighten.
Seat Bottom
16
TOP VIEW
Note: You may want to install the battery before
completing this step. Refer to the Battery Installation
section for instructions.
•
Fit the tabs on the seat bottom into the openings near
the seat back.
•
Push the front edge of the seat down to
in place.
9
Screws
"snap" the seat
P2896pr-0920