Table of Contents
Advertisement
Large
Tab
Large Slots
11
•
Position the windshield so the molded detail on the
wiper faces the front of the vehicle.
Hint: The windshield will only fit one way. If it does not
seem to fit, turn it around and try again.
•
Insert and
"snap" the two large tabs on the
windshield into the large slots in the dash.
•
Pull up on the windshield to be sure it is secure.
Short Seat Belt
Slots
"T" End
Slot
Long Seat
Belt Strap
12
•
Insert the "T" end of a short seat belt up through
a slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
•
Pull up on the short seat belt to be sure it is secure in
the slot.
•
Repeat this procedure to assemble the other short
seat belt.
•
Insert the fastener ends of the long seat belt strap
through the slots in the center of the seat. Make sure
the fasteners face the outer edge of the seat. Pull each
side of the long seat belt strap evenly through the
slots until each T-loop is pulled through the slot.
ASSEMBLY
Windshield
Large Tab
Seat
Short Seat Belt
"T" End
Slot
T-loops
Tab
C
Slot
Slot
13
TOP VIEW
•
With the seat at an angle, insert the two tabs on the
front edge of the seat into the slots in the foot-well
wall
.
A
•
Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots
•
Rotate the back of the seat down
tabs into the slots in the vehicle. Push down firmly on
the seat back.
#10 x ¾" Screw
14
BACK VIEW
•
Insert a #10 x ¾" screw into the rear edge of the seat
and tighten.
11
Tabs
B
PUSH
HERE
A
Slots
.
B
to snap the seat
C
T6137pr-0920
Advertisement
Table of Contents
