Hill Ramp; Speed Ramp; Speed Jump - Fisher-Price Big Action Garage Instructions Manual

Elevator Tower
Side Support
Legs
Base
• Remove the instructional labels from the base and discard
them.
• Position the ramp assembly over the base. Make sure the
elevator tower, side support legs, and connector tube align with
the recesses on the base, as shown.
• Push down firmly on the tower roof to snap the elevator tower
into the base.
• Push down firmly on the top of each side support leg to snap
the side support into the base.
• Pull up on the elevator tower and top floor to make sure the
ramp assembly is secured to the base.
Spiral
Ramp
Spiral
Ramp
• Push down firmly at the base of the upper spiral ramp to snap it
into the center floor.
• Push down firmly at the base of the lower spiral ramp to snap it
into the base.
Helpful Hint: You will hear a "click" when each tab on the
spiral ramps snaps into the center floor or base.
• Pull up on each spiral ramp to make sure it is secured to the
garage floor.
Connector
Tube
Push Here
Tower
Roof
Top Floor
• Insert and firmly snap the tabs on the top of the hill track into
the slots in the elevator tower. You will hear a "click" when each
tab snaps into the elevator tower.
• Insert and firmly snap the tabs at the bottom of the hill ramp
into the slots in the top floor. You will hear a "click" when each
tab snaps into the top floor.
• Pull up on the hill track to make sure it is secured to the
elevator tower and the top floor.

Speed Ramp

Slot
Jump
Lever
• Position the speed ramp so that the underside is facing you.
• Insert the jump lever up through the slot in the speed ramp, as
shown 16A .
• Turn the speed ramp so that the top faces you.
• Insert the pin on the end of the jump lever into the hole in the
speed ramp
Speed Ramp
• Insert the pins on the sides of the speed jump into the holes in
the sides of the speed ramp.
6
Hill Track
Tabs
Slots
Pin
Jump
Lever
.
16B

Speed Jump

Pin
Hole
Tabs
Elevator
Tower
Hole
Pin
Hole