Settings Via The Secur Phone Ip - Depaepe Telecom Securphone IP User Manual

SecurPhone IP – User Guide
In 'Home' interface, select 'Status', to consult the configuration.
In web interface, select 'Network  Basic'.
DHCP: By default, the phone will try to contact a DHCP server, in your network to
obtain valid network settings (IP address, subnet mask, Gateway, DNS, etc).
PPPoE: if you use a xDSL modem, you can connect the phone to internet in PPPoE
mode. Please contact your IAP to obtain the login and password.
Static IP Address: if the phone cannot be connected to a DHCP server, you must
manually enter the network settings in this section.
Note: Please pay attention, wrong network settings may prevent the access to your
phone, and the inefficiency of your network. Contact your network administrator if you
have any doubt.
- SIP account settings:
In web interface, select 'Account  Basic'. The following settings will appear and can be
modified:
Account active: Choose No /Yes to active/enable the account.
Primary SIP server: Proxy, server data for registration, provided by IAP.
SIP user ID : Account, information about user account, provided by IAP.
Authenticate ID : Extension, for authentication purpose, provided by IAP.
Authenticate password: Password, for registration, provided by IAP.
4.5. Settings via the SecurPhone IP
According to the model, use its internal or external keypad.
DHCP mode :
- Pick up the handset and dial ***
- dial 01
- after the voice message,
Static IP mode:
- Pick up the handset and dial ***
IP address:
- dial 02
- after the voice message, enter IP address
Subnet mask:
- dial 03
- after the voice message, enter 12 mask IP address digits
Gateway:
- dial 04,
- after the voice
DNS:
- dial 05,
- after the voice
press '9' to change 'DHCP' mode or 'Static IP'.
message, enter 12 gateway IP address digits (Ex.192168000001).
message, enter DNS IP address (Ex. 202101103054).
(Ex. 192168000250).
(Ex. 255255255000).
34