Table of Contents
Advertisement
Improper use can damage equipment and pro-
perty:
• Working with worn or damaged
carbide inserts or milling heads will
cause the machine to fail.
• Make sure the cable is directed
behind and away from machine. Do not lay the
cable over sharp edges.
•
Avoid collisions when working with machine.
•
Never lift or carry machine by its power cable.
• Always use genuine GERIMA spare parts and
accessories.
Damages caused by wrong power supply!
• Check the supply voltage. It must
correspond with the specifications
on the type plate of the machine.
Risk of electric shock! Warning of
physical injury by electricity
• All work on the machine's electrical systems
must be performed only by qualified electrical
technicians.
• Electrical equipment must be checked regularly.
• Any loose connections must be reattached and
any damaged wires or cables replaced immedi-
ately.
• Never attempt to clean electrical equipment or
systems with water or other similar liquids.
• Use only genuine replacement fuses that match
the specified voltage and current.
• The machine should always be supplied with
powervia a residual current device (RCD) with a
rated current of 30mA or less
Machine hazards :
• The machine has been built in accordance with
the latest engineering standards and generally
recognized safety principles. Nevertheless, im-
proper use can result in serious or fatal injury to
the user and/or third parties or cause damage
to the machine or other property. The operator
is obligated to comply with the applicable laws
and regulations, especially when used outside
the EU. This is especially the case if the exten-
ded claims have to be implemented by
©
.
Basic safety instructions
appropriate amendments to laws and regulations.
The machine must only be used:
• For its intended purpose.
• If it is safe and in good repair.
• In compliance with the operating manual and by
persons who are aware of the safety issues and
hazards associated with the machine.
• Faults that could affect the safety of the machine
must be remedied immediately.
Regular pre-start safety precautions
• Check and ensure that all of the
machine's safety and protective
equipment is in place and function-
ing correctly.
• Check the machine for visible signs of damage.
Any defects or deficiencies identified must be
remedied immediately or reported to the supervi-
sor. The machine may only be used if it is safe
and in a state of good repair.
• Check and ensure that only authorized persons
are within the machine's work area and that no
other persons can be endangered by switching
on the machine.
• All objects and other materials that are not nee-
ded for the operation of the machine must be
removed from the machine's work area.
• The measures to be taken in an emergency are
known.
Basic Safety Measures for Normal Operation:
• The machine may only be started
from the specified workstation.
• Two-handed operation: Whatever
the position of the machine, always
use two hands to control the machine!
• During operation of the machine safety devices
must not be removed or rendered inoperable.
• The operator may be present only at the spe-
cified workplace during operation of the machine.
• The operator must ensure that no unauthorized
persons are in the working area of the machine.
• After switching off the machine, the operator
must wait until all moving parts have stopped and
the lights are off function.
10
Advertisement
Table of Contents
