Fanimation KERRING FP3073 Series Instructions Manual page 11

How to Wire Your Ceiling Fan (Continued)
GROUND GREEN
L BLACK
N
WHITE
AC POWER
L1
RED
3. - Connect green wires from hanger bracket, hanger ball and ground from supply using wire connector.
- Connect black wire from receiver unit marked "AC IN L" to black supply wire using wire connector.
- Connect white wire from receiver unit marked "AC IN N" to white supply wire using wire connector.
- Connect white wire from receiver unit marked "TO MOTOR N" to white wire from fan and white wire from
LED driver using wire connector.
- Connect black wire from receiver unit marked "TO MOTOR L" to black wire from fan using wire connector.
- Connect blue wire from receiver unit to blue wire from LED driver marked "LIGHT" using wire connector.
- Connect blue wire from fan marked " - " to blue wire from LED driver marked " - " using wire connector.
- Connect red wire from fan marked " + " to red wire from LED driver marked " + " using wire connector.
(Figure 4)
NOTE: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
4. After connections have been made, the wires
should be spread apart with the grounded conductor
and the equipment-grounding conductor on one side
of the outlet box and the ungrounded conductor on the
other side of the outlet box, then turn leads upward
and carefully push leads into the outlet box, with the
white and green leads to one side of the box and the
black leads to the other side. (Figure 5)
BLACK
WHITE
BLACK
ANTENNA
WARNING
HANGER
BRACKET
HANGER
BALL
BLUE
WHITE
BLACK
Figure 4
Wire
Connectors
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
11
BLUE BLUE
LED DRIVER
WHITE RED
WHITE
BLACK
HARDWARE USED:
White Wire
from Supply
White Wire
from Receiver
Receiver
Figure 5
-
+
-
+
x 9
Listed
Outlet Box
Household
Supply
Red Wire
from Supply
Black Wire
from Supply
Black Wire
from Receiver