Problem solving guide
Indicator lights or information on the time display
Problem
The indicator light
comes on at the end of
the programme.
lights up
Bars flash in the display
at the end of a pro-
gramme:
.........
Lines flash and light up
after switching on: .
Programme selection is
not possible.
: lights up and the
programme has been
cancelled, a signal
sounds
48
Cause and remedy
The tumble dryer is not working correctly or econom-
ically. Possible causes could be clogging caused by
fluff or detergent residue.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Please see "Cleaning and care" for notes on clean-
ing.
Clean the fluff filters.
Also check the plinth filter and clean it if neces-
sary.
You can influence when the indicator lights up.
To do this, follow the instructions in "Program-
mable functions – Airways indicator".
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
The PIN code is activated.
See "Programmable functions", " PIN code".
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.