INTRODUCTION Welcome to the world of Citizens Band radio communications. Your Uniden radio is an advanced mobile radio designed for use in the Citizens Band (CB) Radio Service. It will operate on any of the 40 AM frequencies authorized by the Federal Communications Commission (FCC).
INCLUDED IN YOUR PACKAGE If any of these items are missing or damaged, immediately contact your place of purchase or Uniden’s Parts Department. ANL CH9 RF GAIN PRO520 XL Mobile radio Microphone and hook Mounting bracket and knobs Mounting hardware Other printed materials NOTE: You must use a CB antenna (sold separately) with this radio.
Page 4
3. CH9 Switch Switches the radio over to channel 9. 4. TX LED Indicates when the radio is transmitting. 5. S/RF (Signal/RF) Meter Shows the strength of the received signal or the RF output. 6. Channel Indicator Displays the channel currently in use. 7.
NOTE: Make sure you have read and understood part 95 of the FCC rules and regulations before using the transmitter. INSTALLATION Connect the microphone Align the microphone connector with the jack on the front of the radio. Connect the power You can connect the radio to any standard 12 volt DC power source, with either a positive or negative ground.
CAUTION: Make sure the SWR is less than 2:1 before using the radio. An SWR higher than 2:1 can damage the transmitter. Your Uniden dealer can help you select the antenna that is best for your transmitter and antenna information.
External monior PA speaker The internal speaker is You must have a PA Notes disabled when an external speaker connected to speaker is connected. use the PA feature. NOTE: FCC rules reserve Channel 9 for motorist assistance and other emergency communications. Channel 9 should only be used in situations where there is immediate danger to the safety of individuals or the protection of property.
► All mounting screws are securely fastened. ► Inspect all screws and other mounting hardware. TROUBLESHOOTING If your radio is not performing to your expectations, please try these simple steps. If these steps don’t solve your problem, visit www.uniden.com for assistance. Problem: Things to try: 1.
Background 1. Turn on the automatic noise limiter. noise 2. Adjust the squelch level. 1. Check the antenna, cable and connectors. Weak 2. Check the antenna grounding. transmission 3. Check for corrosion on the connectors. Service and repair information ► Service, repair, or alignment should only be attempted by a qualified and/ or licensed radio technician.
SPECIFICATIONS eneral Channels 40 AM Frequency Range 26.965 to 27.405 MHz Frequency Control Phase Locked Loop (PLL) synthesizer Frequency Tolerance ±0.005% Operating -30ºC to +50ºC Temperature Microphone Plug in type, dynamic Input Voltage 13.8 V DC nom. (+ or - ground) Current Drain TX full mod., 1.7A with max.
Page 11
FCC PART 15 & IC COMPLIANCE INFORMATION FCC PART 15 COMPLIANCE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”) ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale.
Page 13
The product should be shipped freight prepaid, by traceable means, to warrantor at: Uniden America Service C/O Saddle Creek 743 Henrietta Creek Rd., Suite 100...