Stihl FSB-KM Instruction Manual page 5

STIHL recommends the use of genuine
STIHL tools and accessories. They are
specifically designed to match the
product and meet your performance
requirements.
The guard provided with your machine
may not protect the operator from all
foreign objects (gravel, glass, wire etc.)
ejected by the revolving cutting
attachment. Ejected objects may also
ricochet and strike the operator.
Never attempt to modify your power tool
in any way since this may increase the
risk of personal injury. STIHL excludes
all liability for personal injury and
damage to property caused while using
unauthorized attachments.
Do not use a high-pressure washer to
clean the power tool. The solid jet of
water may damage parts of the unit.
Clothing and equipment
Wear proper protective clothing and
equipment.
Clothing must be robust
but allow complete free-
dom of movement. Wear
close-fitting clothes such
as a boiler suit, not a
loose jacket.
Do not wear clothing which could
become trapped in wood, brush or
moving parts of the machine. Do not
wear a scarf, necktie or jewelry. Tie up
and confine long hair above your
shoulders.
FSB-KM
Wear sturdy shoes with
non-slip soles.
WARNING
To reduce the risk of eye
injuries, wear close-fit-
ting safety glasses in
accordance with Euro-
pean Standard EN 166.
Make sure the safety
glasses are a snug fit.
Wear face protection and make sure it is
a good fit. Face protection alone is not
sufficient to protect the eyes.
Wear "personal" sound protection, e.g.
ear defenders.
Wear sturdy protective
gloves made of a resist-
ant material (e. g.
leather).
STIHL can supply a comprehensive
range of personal protective equipment.
Transporting the machine
Always stop the engine.
Carry the unit properly balanced by the
shaft or loop handle.
By vehicle: When transporting in a
vehicle, properly secure your machine to
prevent tipping over, damage and fuel
spillage.
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the
KombiEngine and KombiTool user
manuals:
Use only an approved combination
–
of cutting attachment, deflector,
handle and harness. All parts must
be assembled properly and
securely
Check cutting attachment for
–
correct and secure assembly and
good condition
Check safety devices (e. g.,
–
deflector for cutting attachments) for
damage and/or wear. Always
replace damaged parts. Never
operate the unit with a damaged
deflector
Never attempt to modify the controls
–
or safety devices.
Keep the handles dry and clean –
–
free from oil and dirt – this is
important for safe control of the
machine
Adjust harness and handle to suit
–
your height and reach. Observe the
chapter "Fitting the Harness"
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
English
3