Table of Contents
Advertisement
Available languages
Available languages
Technical data
Model
Type nº
Power input [W]
127 V
Amperage [A]
220 V
No-load speed [min
]
–1
Saw blade [mm]
Cut depth - 90° / 45° [mm]
Base plate [mm x mm]
Weight (without access.) [kg]
Protection Class
Machine elements
1 Safety switch
2 Auxiliary handle
3 Blade shaft
4 Lock button
5 Calibrated bevel quadrant
6 Bevel adjustment knob
7 Lower guard
8 Inner washer
9 Blade
10 Blade stud
11 Outer washer
12 Base plate
13 Lower guard lift lever
14 Dust port
15 Upper guard
Generality
The machine is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles to 45° in
plywood and chip board as well as wood fibre and laminat-
ed materials while in firm contact with the material.
Noise / Vibration information
Measured values determined according to IEC 60745.
Typically the A-weighted noise levels of the tool are: sound
pressure level 100 dB (A); sound power level 113 dB (A).
Wear ear protection!
The typical hand-arm vibration is below 2,5 m/s
For your safety
Working safely with this machine is possible
only when the operating and safety information
are read completely. Additionaly safety instruc-
tions (page 18) must be followed. Before using
for the first time, ask for a practical demonstration.
16
manual skil 5300
5300
F 012 530 0..
1300
10,5
5,9
5000
Ø 184 x 1,6 x Ø16
62 / 49
290 x 140
4,33 kg
/ II
2
.
16
• If the cable is damaged or cut though while
working, do not touch the cable but immediately
pull the mains plug. Never use the machine with
a damaged cable.
• Wear safety glasses, hearing protectors and
protective gloves. Wear a face mask.
• For long hair, wear hair protection. Work only
with close-fitting clothes.
• The machine must not be operated without the appropri-
ate safety devices.
• The swinging protective guard must be able to move free-
ly and must not be jammed in the open position.
• Always lay the cable away from the machine to wards the
rear.
• Put the plug into the mains socket only when the ma-
chine is switched off.
• Do not leave clamping tools inserted.
• Clamp the work-piece if it cannot be secured by its own
weight.
• Always hold the machine with both hands during opera-
tion and make sure you have a firm foot-hold.
• Apply the machine to the material only after it has been
switched on.
• When working, always guide the machine away from the
body.
• The cutting path must be free of obstacles on the top and
the bottom.
• The saw blade should not protrude below the workpiece
more than 3 min.
• Keep hands away from the rotating saw blade. Be careful
not to come in contact with the rotating saw blade on the
underside of the workpiece.
• Do not work overhead with the machine
• Do not cut into nails, screws, etc.
• Do not work with materials containing asbestos.
• Do not tilt the saw blade.
• If the saw blade becomes jammed, switch off the ma-
chine immediately.
• Do not stop the saw blade after switching off with side
11.02.04, 07:54
Advertisement
Table of Contents
