Table of Contents
Advertisement
201072 - 3650W WIRELESS REMOTE START GENERATOR
Setting the Remote Key fob
The remote key fob comes already synchronized to the generator.
If for some reason the remote key fob is not synchronized or the
battery in the fob needed to be replaced, the fob will need to be
resynchronized. Up to two remote key fobs can be synchronized
to the generator at a time. Follow the proceeding steps to reset a
remote or synchronize two remotes:
1. Turn the fuel dial to the "ON" position.
2. Press the SSS button to enter standby mode.
3. Push and hold the wireless set button found on the right side
of the control panel for approximately three seconds until the
red light turns on.
4. Push and release the "STOP" $ button on the remote key
fob. The red light blinks once to erase the remote program.
5. Push and release the "START" a button on the remote key
fob. The red light blinks once to program the remote.
6. Push and hold the wireless set button for approximately three
seconds until the red light turns off.
7. Follow the remote START and STOP instructions to verify the
remote(s) are working properly.
Two remote key fobs can be synchronized to the generator at
one time. If pairing second remote and do not want to erase
programming on current remote, skip step 4.
Changing a remote key fob battery may not require the user to
reset the remote. If remote does not function after changing
the battery, proceed with Setting the Remote Key Fob
instructions.
21
OPERATION
NOTICE
NOTICE
Advertisement
Table of Contents
