Table of Contents
Advertisement
201072 - 3650W WIRELESS REMOTE START GENERATOR
Remote Key fob battery
– Battery Replacement: CR2016
– Clean the battery contacts and also those of the device
prior to battery installation.
– Remove batteries if expended or if product is to be left
unused for a long period of time.
1. Remove the remote key fob from the key ring.
2. Remove the screw with a Phillips screwdriver (not included)
by turning counter clockwise.
3. Pry the two halves of the remote key fob apart slightly at the
key ring end.
4. Separate the two halves of the remote key fob by sliding the
back side of the remote key fob up toward the key ring end.
5. Carefully remove the circuit board to locate and replace the
CR2016 battery.
6. Reverse the above instructions to reassemble the remote key
fob.
Maintenance Schedule
Follow the service intervals indicated in the following maintenance
schedule.
Service your generator more frequently when operating in adverse
conditions.
Contact our Technical Support Team at 1-877-338-0999 to locate
the nearest CPE certified service dealer for your generator or
engine maintenance needs.
EVERY 8 HOURS OR PRIOR TO EACH USE
— Check oil level
— Clean around air intake and muffler
FIRST 5 HOURS (BREAK IN)
— Change oil
NOTICE
EVERY 50 HOURS OR ANNUALLY
— Clean air filter
— Change oil if operating under heavy load or in hot
environments
EVERY 100 HOURS OR ANNUALLY
— Change oil
— Clean/adjust spark plug
— Clean spark arrestor
— Clean fuel valve filter*
EVERY 250 HOURS
— Clean combustion chamber*
— Check/adjust valve clearance*
EVERY 3 YEARS
— Replace fuel line*
* To be performed by knowledgeable, experienced owners or CPE certified service
centers.
STORAGE
To avoid accidental or unintended ignition of your generator
during periods of storage, the following precautions should be
followed:
– When storing the generator make sure the fuel dial is set to
the "OFF" position.
Short Term Storage (30 days – 1 year)
Ethanol blended gasoline in the tank has a maximum shelf life
of up to 1 year with the addition of a properly formulated fuel
stabilizer and stored in a cool, dry place.
1. Be sure all appliances are disconnected from the generator.
2. Add a properly formulated fuel stabilizer to the gasoline tank.
3. Turn the fuel dial to the "ON" position.
4. Start and run the generator for 10 minutes so the treated
gasoline cycles through the fuel system.
5. Turn fuel dial to the "OFF" position and allow generator to
cool completely before continuing.
6. Remove the drain bolt on the carburetor to empty any excess
gasoline from the carburetor into an appropriate container.
Use a funnel (and appropriate hose if necessary) under the
carburetor drain bolt to avoid spillage.
29
WARNING
STORAGE
Advertisement
Table of Contents
