Checking The Printer; Connecting To Power - U-Line ZEBRA ZD410 Manual

1. Check all exterior surfaces for damage.
CAUTION! The discharge of the electrostatic
energy that accumulates on the surface of the
human body or other surfaces can damage or
destroy the print head or electronic components
in the printer. Observe static-safe procedures
when working with the internal components of
the printer.
2. Open the printer by pulling the release laches and
lifting the cover. (See Figure 1)
3. Inspect the media compartment for damage to
components.
CAUTION! Never operate the printer and power
supply in an area where they can get wet.
Serious personal injury could result.
Ensure a three prong plug and an IEC 60320-C13
connector are used at all times. This power cord
must bear the relevant certification mark of the
country in which the product is being used.
Figure 2
Printer
PAGE 3 OF 18

CHECKING THE PRINTER

CONNECTING TO POWER

Power Switch
Power Connector
Power Receptacle
Figure 1
1. Plug the power supply into the printer's DC power
receptacle.
2. Insert the AC power cord into the power supply.
3. Plug the other end of the power cord into an AC
electrical outlet.
4. The active power light will turn on.
(See Figure 2)
Active Power Light
Power Supply
AC Power Cord
IEC 60320-C13
0518 IH-6323