Table of Contents
Advertisement
●
Resuming Adaptive Cruise Control in stay-stopped status
Setting using the RES/SET switch
Even when the vehicle in front remains stopped, Adaptive Cruise Control can be activated
by operating the RES/+ switch or SET/- switch.
indicator) turn off, and
• Press the SET/- switch. The speed is automatically set to 20 mph (30 km/h).
• Press the RES/+ switch. The vehicle speed that was set before the stay-stopped function
activated is set again.
Page 66
When Adaptive Cruise Control is resumed from stay-stopped status and the
vehicle in front accelerates, your vehicle will also accelerate and continue to fol-
low the vehicle in front at the previously set following distance. However, if the
lead vehicle does not start moving or pauses, stay-stopped status will be auto-
matically restored after approximately 3 seconds.
Setting with the accelerator pedal
Depressing the accelerator pedal while stay-stopped is engaged cancels stay-stopped sta-
tus. At this time, Adaptive Cruise Control is resumed. The vehicle will attempt to travel at the
previously set vehicle speed unless a lead vehicle is detected. If a lead vehicle is detected,
Adaptive Cruise Control will maintain the previous following distance setting.
When the stay-stopped function is canceled, the vehicle will start. Make sure the
surroundings are safe before canceling the stay-stopped function.
If the accelerator pedal is only slightly depressed, the stay-stopped function may
not be canceled, and the Adaptive Cruise Control may not be resumed.
(SET indicator) turns on.
NOTE
WARNING
NOTE
Adaptive Cruise Control
(HOLD indicator) and
(READY
61
Advertisement
Table of Contents
