Ethernet Board - PROIETTA CASE AF10 Instruction Manual

BLUETOOTH BOARD (STANDARD)
ETHERNET BOARD (ON
Configuring the case's network address relative to your network (access from LAN)
The network address must be configured based on the parameters of your network by
typing IP and password.
DEFAULT NETWORK PARAMETERS
IP: 192.168.1.233
NET MASK: 255.255.255.0
GATEWAY: 192.168.1.1
Reset the Bluetooth Module PIN —> Push Button A
To reset the PIN press the button, indicated with the
red circle on the Bluetooth module, for at least 2
seconds and the PIN becomes: 0000000.
Button A
REQUEST)
Reset the Bluetooth Module PIN —> Push Button A
To reset the PIN press the button, indicated with the red
circle on the Bluetooth module, for at least 2 seconds and
the PIN becomes: 0000000.
Reboot/Reset to Factory —> Push Button B
Hold the button down for two seconds until a red led lights
up. By stopping pressing the board restarts (Reboot) and the
led shuts down again.
Button B
Holding down the button for 10 seconds the led turns off
and when it is re-lighting, the board will be formatted to the
factory settings (Reset to Factory).
Button A
Reset to Factory resets the board account and IP to the
default network parameters.
11