Limitations Of Use; Installation - Taylor ARC4000 Series Operating Manual

IMPORTANT SAFETY INFORMATION !
5. TRAINING
Use of the equipment must be limited to authorised personnel only who must be suitably
trained and must have read and understood this manual. This manual must be made
available to all operators at all times. Further copies of this manual may be purchased from
the manufacturer. Measures must be taken to prevent the use of this equipment by
unauthorised personnel.

6. LIMITATIONS OF USE

The mass of the welding controller is 150kg and not suitable for man lifting. It is fitted with
suitable castors to enable man powered movement on flat, level, smooth surfaces only. The
welding controller is also fitted with appropriate lifting points to allow lifting by crane/
forklift truck. The controller is not suitable for use in rain or snow or in an environment with
increased risk of electric shock.

6. INSTALLATION

Ensure that the site chosen for the equipment is able to support the weight of the
equipment and that it will not fall or cause a danger in the course of its normal operation.
Do not hang connecting cables over sharp edges and do not install connecting cables near
heat sources or via traffic routes where people may trip over them or they may be
damaged by the passage of vehicles (forklifts etc).
7. INTERFERENCE
During welding operations, intense magnetic and electrical fields are unavoidably produced
which may interfere with other sensitive Electronic equipment.
All Taylor Studwelding equipment is designed, manufactured and tested to conform the
current appropriate European standards and directives regarding electromagnetic
emissions and immunity and as such is safe to use in any normal environment.
8. DISPOSAL
The equipment either wholly or any of its component parts may be disposed of as part of
general industrial waste or passed to a scrap merchant. None of the components used in
the manufacture are toxic, carcinogenic or harmful to health in their "as supplied"
condition.
6
V-21A