Further Information - Taylor ARC4000 Series Operating Manual

USEFUL INFORMATION

FURTHER INFORMATION

Should you require additional technical information, please contact us directly (details
on previous page) or our local agent / distributor (details of agents etc. can be obtained
from us).
This guide contains important information which is a pre-requisite for safe Operation
of the equipment. The operating personnel must be able to consult this guide when
necessary. In the interests of safety, make this guide available to your personnel in good
time.
If the equipment is sold / passed on, please hand over this manual to the new owner
and if possible please inform us of the name and address of the new owner, in case we
need to contact him regarding the safety of the machine.
PLEASE READ THIS GUIDE CAREFULLY BEFORE INSTALLING OR OPERATING THE
CONTROLLER.
PLEASE OBSERVE CAREFULLY ALL SAFETY PROCEDURES/INSTRUCTIONS.
DUE TO THE POWER REQUIREMENTS AND ELECTROMAGNETIC EMISSIONS
PRODUCED DURING NORMAL USE, THIS MACHINE MUST ONLY BE OPERATED IN
AN INDUSTRIAL ENVIRONMENT.
THIS MACHINE OPERATES FROM A MAINS SUPPLY OF 380/415V AC @ 50/60 Hz
NEVER REMOVE ANY PORTION OF THE UNIT HOUSING WITHOUT FIRST
ISOLATING THE CONTROLLER FROM THE MAINS ELECTRICAL SUPPLY.
NEVER OBSTRUCT THE UNDERSIDE, FRONT OR REAR PANELS AS THIS MAY
CAUSE THE UNIT TO OVERHEAT DURING OPERATION.
DO NOT USE THIS WELDING POWER SOURCE FOR PIPE THAWING.
THIS EQUIPMENT HAS BEEN EMC TESTED AND APPROVED IN ACCORDANCE
WITH BS EN 60974-10 (CATEGORY 2).
Taylor Studwelding Systems Limited reserves the right to amend the contents of this guide without notification.
4
V-21A