Advertisement
Always follow these safety precautions to avoid injury and damage to storage system equipment.
If equipment described in this guide is used in a manner not specified by the documentation, the protection provided by the
equipment could be impaired. For your safety and protection, observe the rules described in the following sections.
Follow these safety precautions:
● It is recommended that only individuals with rack-mounting experience install the system in a rack.
● You need at least two people to lift the storage system chassis from the shipping box and three people to install it in the
rack. Refer to the
Technical specifications
systems.
● Make sure the storage system is always fully grounded to prevent damage from electrostatic discharge.
● When handling the storage system hardware, use an electrostatic wrist guard (not included) or a similar form of protection.
The chassis must be mounted in a rack. The following safety requirements must be considered when the chassis is being
mounted:
● The rack construction must be capable of supporting the total weight of the installed chassis. The design should incorporate
stabilizing features suitable to prevent the rack from tipping or being pushed over during installation or in normal use.
● To avoid danger of the rack toppling over, slide only one chassis out of the rack at a time.
● The storage system must be operated with low-pressure rear exhaust installation (back pressure created by rack doors and
obstacles not to exceed 5 Pascals [0.5 mm water gauge]).
Installation safety precautions
in this document for the exact weights of the models of the ME4 Series storage
Installation safety precautions
3
5
Advertisement
