Advertisement
Setting up the ME4 Series expansion
Consider the following best practices when setting up an ME4 Series expansion enclosure.
● Before connecting any cables between the storage system and the host server or expansion enclosure, physically label each
port and connector.
● Always follow proper power-up and power-down procedures when cycling power across the network. Verify that critical
network components are on separate power circuits.
WARNING:
If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified
by the manufacturer.
NOTE:
This product is intended for restricted access locations, such as a dedicated equipment room or equipment closet.
Safety warnings
Heavy weight warning
A fully configured ME484 enclosure can weigh up to 130 kg (287 lb). An
unpopulated storage system weighs approximately 64 kg (141 lb).
High temperature warning
The operating temperature inside the drawers of ME484 storage systems can
reach up to 60°C (140°F). Take care when opening drawers and removing drive
carriers.
Electrical disconnection warning
The system may have more than one PSU cable. To reduce the risk of electrical
shock, a trained service technician may need to disconnect all PSU cables before
servicing the system.
CAUTION:
Class I laser radiation when open, avoid exposure to beam.
WARNING:
Laser radiation, avoid direct exposure to beam.
The unit is certified in the U.S. to conform to the requirements of DHHS 21 CFR,
chapter 1 Subchapter J for Class I (1) laser products, and elsewhere is certified as
a Class I laser product conforming to the requirements of IEC 60825-1.
Class I laser products are not considered to be hazardous. The laser system and
unit are designed so there is never any human access to laser radiation above a
Class I level during normal operation, user maintenance or prescribed service
condition.
Setting up the ME4 Series expansion enclosure
1
enclosure
3
Advertisement
