Connection And Switching On; Connecting The Foot Control; Connecting The Machine - Bernina 735 User Manual

Sewing preparation
NOTICE Scratched sensor surfaces of the bobbin
Malfunction of the lower thread indicator. If the sensor surfaces of the bobbins are scratched or dirty, the
bobbin thread indicator will no longer detect the low thread level.
> Always position the bobbins in the bobbin holder with the silver sensor surface to the right.
> Insert the bobbins into the compartment (6) of the accessory box so that the silvery sensor surfaces are
> To remove a bobbin, press the compartment holder down.
> Store the presser feet in the holders (7) (5.5 mm).

2.3 Connection and Switching on

Connecting the foot control

The cable of the foot control is rolled up on its underside.
> Unroll the cable of the foot control to the desired length and fix it in the cable holders of the foot
> Insert the plug of the cable into the foot control socket of the machine.
> Place the foot control under the table.
> If the cable is too long, roll up the excess length and fix it in the cable holders of the foot control.

Connecting the machine

To ensure safe operation of the machine, only the supplied mains cable may be used. The supplied power
cable is designed for the voltage range applicable in the country of use. If the machine is to be used in a
country other than the country of origin, the power cable suitable for that country must be obtained from
the Authorized BERNINA dealer.
The power cable for USA and Canada has a polarized plug (one blade wider than the other). To reduce the
risk of electrical shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit
into the outlet, turn the plug upside down and plug it in. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the plug in any way.
30
on the right side.
control..