Cisco Firepower 1010 Getting Started Manual page 95

Hide thumbs Also See for Firepower 1010:
Table of Contents

Advertisement

Firepower Threat Defense Deployment with FMC
Figure 39: Cabling the Firepower 1010
Note
For version 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
Procedure
Step 1
Connect Management1/1 directly to one of the switch ports, Ethernet1/2 through 1/8.
Step 2
Cable the following to the switch ports, Ethernet1/2 through 1/8:
• Firepower Management Center
• Management computer
• Additional end points
Step 3
Connect the management computer to the console port. You need to use the console port to access the CLI
for initial setup if you do not use SSH to the Management interface.
Step 4
Connect Ethernet 1/1 to your outside router.
Cable the Device (6.5 and Later)
Cisco Firepower 1010 Getting Started Guide
93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents