Cisco Firepower 1010 Getting Started Manual page 155

Firepower Threat Defense Deployment with a Remote FMC
Link
Channels
Mode
MDI/MDIX
MTU
MAC Address
----------------------[ IPv4 ]----------------------
Configuration
Address
Netmask
Gateway
----------------------[ IPv6 ]----------------------
Configuration
===============[ Proxy Information ]================
State
Authentication
======[ System Information - Data Interfaces ]======
DNS Servers
Interfaces
===============[ GigabitEthernet1/1 ]===============
State
Link
Name
MTU
MAC Address
----------------------[ IPv4 ]----------------------
Configuration
Address
Netmask
Gateway
----------------------[ IPv6 ]----------------------
Configuration
Check that the FTD registered with the FMC
At the FTD CLI, check that the FMC registration was completed. Note that this command will not show
the current status of the management connection.
show managers
> show managers
Type
Host
Registration
>
Ping the FMC
At the FTD CLI, use the following command to ping the FMC from the data interfaces:
ping fmc_ip
At the FTD CLI, use the following command to ping the FMC from the Management interface, which
should route over the backplane to the data interfaces:
ping system fmc_ip
Troubleshoot Management Connectivity on a Data Interface
: Up
: Management & Events
: Non-Autonegotiation
: Auto/MDIX
: 1500
: 28:6F:7F:D3:CB:8D
: Manual
: 10.99.10.4
: 255.255.255.0
: 10.99.10.1
: Disabled
: Disabled
: Disabled
:
: GigabitEthernet1/1
: Enabled
: Up
: outside
: 1500
: 28:6F:7F:D3:CB:8F
: Manual
: 10.89.5.29
: 255.255.255.192
: 10.89.5.1
: Disabled
: Manager
: 10.89.5.35
: Completed
Cisco Firepower 1010 Getting Started Guide
153