Cisco Firepower 1010 Getting Started Manual page 22

Configure Licensing
Step 5
Click Register Device. After synchronizing with the device, the connectivity state changes to 'Online'.
You return to the Manage Licenses page. While the device registers, you see the following message:
Step 6 After applying the smart license successfully to the FTD device, the device status shows Connected, Sufficient
License. Click the Enable/Disable slider control for each optional license as desired.
• Enable—Registers the license with your Cisco Smart Software Manager account and enables the controlled
features. You can now configure and deploy policies controlled by the license.
• Disable—Unregisters the license with your Cisco Smart Software Manager account and disables the
controlled features. You cannot configure the features in new policies, nor can you deploy policies that
use the feature.
• If you enabled the RA VPN license, select the type of license you want to use: Plus, Apex, VPN Only,
or Plus and Apex.
After you enable features, if you do not have the licenses in your account, you will see the following
non-compliance message after you refresh the page License Issue, Out of Compliance:
Cisco Firepower 1010 Getting Started Guide
20
Firepower Threat Defense Deployment with CDO and Low-Touch Provisioning