Cisco Firepower 1010 Getting Started Manual page 11

Firepower Threat Defense Deployment with CDO and Low-Touch Provisioning
Figure 1: Cabling the Firepower 1010
Note For 6.7, the inside IP address is 192.168.1.1.
Note Ethernet1/2 through 1/8 are configured as hardware switch ports; PoE+ is also available on Ethernet1/7 and
1/8.
Low-touch provisioning supports connecting to CDO on Ethernet 1/1 (outside). You can alternatively use
low-touch provisioning on the Management 1/1 interface.
Procedure
Step 1
Connect the network cable from the Ethernet 1/1 interface to your wide area network (WAN) modem. Your
WAN modem is your branch's connection to the internet and will be your Firepower firewall's route to the
internet as well.
Note
Step 2 Connect inside devices to the remaining switch ports, Ethernet 1/2 through 1/8.
Alternatively, you can connect the network cable from the device's Management 1/1 interface to
your WAN. Whichever interface you use must have a route to the internet. The Management interface
supports IPv6 if you manually set the IP address at the CLI. See
Network Settings at the CLI, on page
low-touch provisioning.
(Optional) Change Management
34. The outside Ethernet 1/1 interface only supports IPv4 for
Cisco Firepower 1010 Getting Started Guide
Cable the Device
9